GE RR9 Low Voltage Pilot Light Remote Control Relay Switch RR9PBP

Description

General Electric’s RR9 solenoid relay switch features an isolated pilot contact and is the recommended replacement part for older, discontinued GE pilot light relays. Featuring 5 six-inch low voltage leads with a new plug-in connector, this mechanical latching relay uses momentary 24 volt switch pulses to open and close line voltage circuits. These low voltage switch control relays can also be used as replacements in vintage Bryant and Sierra systems.

IN STOCK FOR IMMEDIATE SHIPMENT

Features

• 20 amp, 277 volt RR 9 remote control relays #RR9PBP; (equivalent to RR 9X, RR9X); GE is a 24 Volt AC system
• single pole single throw (SPST) maintained relay, 6″ wire leads with a yellow plug on end
• 1.5″ W x 1.75″ D x 2.5″ H with a 7/8″ diameter cylinder
• five 6″ wire leads – 2 yellow, 1 black, 1 red, 1 blue* with plug end
• simply cut off the yellow plastic plug end for systems not using plug-in relays
• (RR9PBP replaces the non-plug-end RR9 relay shown in second photo)
• unique coil design resists burnout; isolated contacts internal to the relay
• use with #14-10 AWG solid or stranded copper wire
• operates in any position
• GE RR9PBP also replaces older GE RR4, RR6, RR8, RR9 pilot light relays plus Sierra Electric and Bryant relays for lighted switches – use a GE RR7 relay to replace GE RR2, RR3 or RR5
• UL Listed 508G IND. CONT. EQ.; cULus (indicates compliance with both Canadian and U.S. requirement) E18830
• genuine GE brand replacement parts made in India for “Current Lighting Solutions, marked with Current brand
• can replace Sierra or Bryant versions of a similar type

*Wiring Tip: If replacing an older relay such as the RR-8, the wire colors have changed slightly. You will now connect the old red wire to the new red wire, the old black wire to the new black wire, the old yellow wire (or blue/white spiral) to the new yellow wire, and connect the old blue wire to BOTH the second new yellow wire and the new blue wire. Connect the load wire to one of the screw terminals on the relay base and the hot wire to the other. (It doesn’t matter which one – both terminals function the same way).
Detailed Rating Info: Each relay employs s split low-voltage (24V) coil to move the line voltage contact armature to the ON(OFF) latched position. Pilot contact is 1A, 24 VAC isolated. Operating voltage is 24-29 VAC (10%) half or full wave rectified or pure, 30- 38 VDC (10%) filtered. Resistive load is 30A 277 V.A.C. Lamp load – 20A tungsten filament 125 VAC, 20A ballast 277 VAC. Endurance is 50,000 cycles – full load; 100,000 cycles – no load. ( GRR9, GERR9, RR-9 ) May be used to full-rated capacity for tungsten filament, ballast, or resistive loads. This Model RR-9 includes an auxiliary contact on the low voltage side for status indication. Find coordinating GE devices and switch plates at General Electric Low Voltage Lighting Components.

Power Contact Latching for RR9 Relay with Isolated Pilot

20A Tungsten 125VAC 1/2 HP  motor at 110 – 125VAC

30A Ballast 277VAC 1 1/2 HP  motor at 277VAC

30A Resistive 277VAC

20A Ballast 347VAC 1 1/2 HP  motor at 347VAC

20A Resistive 347VAC